Alpha ECG-125 Manuel d'instructions télécharger pdf (Page 27)

REPLACING THE GRINDING WHEEL

1. To replace the grinding wheel follow the steps for removing the grinding wheel (see

page26).Afterthegrindingwheelisremoved,youneedtoremovethethreeat-head

screws holding the drive plate adapter onto the diamond grinding wheel.

Note: When you purchase a replacement Grinding Wheel (Part # DSQ0500), it does not come

with the Drive Plate Adapter (Part # 801381) or Flat Head Screws (Part # 801382).

These parts need to be ordered separately or re-used if still in good condition.

2. CleantheinsideoftheDrivePlateAdapterandcheckforwear.Ifthesquarearboris

worn,itwillpreventthegrindingwheelfromoatingontheangenut,andshouldbe

replaced.

3. Place the Drive Plate Adapter onto the new Diamond Grinding Wheel and align the

holes. A small drop of Loctite thread lock should be applied to each screw to keep it

from loosening. Tighten each screw until seated, then go back around and re-tighten

each screw to secure them evenly.

4. The new Diamond Grinding Wheel can now be reinstalled on the tool.

Grinding wheel, adapter and screws

Figure-27

Drive Plate

Adapter

Grinding Wheel

(26mm Arbor)

Flat Head Screws

(M4x6)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Pas de commentaire

Alpha ECG-125 Manuel d'instructions Page 27