Alpha ECG-125 Manuel d'instructions télécharger pdf (Page 21)

3. Using small needle nose pliers, gently pull the carbon brush holder straight out from

the motor housing. After removing the carbon brush holder from the motor housing,

you need to remove the power wire terminal from the carbon brush holder (Note: the

path of the wire, as it is important for reassembly of the unit). The carbon brush holder

assembly is now free from the machine and can be inspected.

4. Pictured on the left below, is a worn carbon brush in the holder (Note: the twisted wire

isattheendoftheslotandthecarbonbrushisalmostushwithholder).Ontheright

below, is a new carbon brush in the holder.

NOTE: Carbon brushes sometime wear at different rates; however, both carbon brushes

should be replaced at the same time. The carbon brushes in this grinder are located

under the rear handle.

WARNING!

Replacing the carbon brushes in this unit with non-Alpha

parts could damage the unit,

and will void the warranty.

Power Wire

and Terminal

Figure-15

Figure-16

Carbon Brush Removal

Worn and New Carbon Brushes

Worn

New

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Pas de commentaire

Alpha ECG-125 Manuel d'instructions Page 21